Carpeting stairs cap and band installation

The ins and outs of stair upholstery 02 01 floor covering how to install carpet on stairs diy and repair guides how to install carpet on stairs you carpet installation stairs. Related Posts Cowhide Sleeper Sofa.

Ryland Homes Tampa Fl. Mr Floor Carpets Bexhill. This website uses cookies to improve your experience. We'll assume you're ok with this, but you can opt-out if you wish. Accept Read More. Measure the length of the cap and band by adding the riser height to the depth of the tread, and include any step overhang between the tread and the riser.

Cut the carpet to the cap and band length, and cut the carpet 1 inch wider than the stair width, using a utility knife. Center the edge of the carpet at the bottom of the riser and push the carpet onto the angled tacks. Stretch the cap and band carpet piece up the riser using a knee kicker.

Use a staple gun to fasten staples at 3-inch intervals across the top of the riser underneath the step overhang. Wrap the carpet around the overhang and to the back of the tread. Cap and band and waterfall are the most common methods of installing carpet on stairs. While waterfall utilizes a single strip of carpeting on the entire stairway, cap and band calls for a separate piece to be installed on each tread and riser combination. Treads are the parts of the stairs you walk on, and risers are the vertical pieces that connect the treads.

The cap and band method creates a slightly tighter fit, as the carpeting is secured to tacking strips and also stapled to the underside of the stair nosing. If cap and band carpeting becomes worn or stained, it can be replaced in sections rather than replacing an entire stairway.

Measure the width of the treads and the risers. Cut one tacking strip to the appropriate size for each tread and each riser. Make your cuts so that at least two of the prestarted nails in the tacking strip are within each piece.

Make sure the teeth of the tacking strip are pointing down.